Materials supplied by the installer
Make sure you have all other materials required for the
selected installation method and location.
IMPORTANT
•
No mounting hardware, tubing, cables, and other
materials listed below are included with the appliance.
The required materials will vary, but may include the following:
•
1.8 m electrical whip for connecting the power from the
installed disconnect switch to the outdoor unit
•
UV-resistant vinyl line set tape for the exposed line set
•
Lines-set cover and fittings, if used
•
Miscellaneous pipe hangers
•
Miscellaneous screws and anchors for hanging pipe
hangers, the line-set cover, the indoor unit mounting
bracket, and so on.
•
Electrical ring connectors for connecting all power and
communication wiring
•
Electrical tape
•
Refrigerant R-32 if additional refrigerant is required
due to line-set length
•
Closed cell foam tape insulation (roll)
•
Outdoor unit risers or L-brackets for wall installation
•
Silicone caulking for sealing the wall penetration
•
Rags
Tools
Make sure you have the required tools available.
General tools
•
Vacuum pump
(Backward flowing prevention)
•
Manifold gauge
•
Stud finder
•
Torque wrench
•
Pipe cutter
•
Reamer
•
Pipe bender
•
Spirit level
•
Screwdriver
•
Spanner
•
Drill
•
L-wrench
•
Measuring tape
Tools for test operation
•
Thermometer
•
Resistance meter
•
Electroscope
English
13