U24Rl Rear Lounge - Leisure Unity 2020 Owner's Manual

APPLIANCE AND EQUIPMENT OPERATION

U24RL REAR LOUNGE

LOWERING THE MURPHY BED
1. Remove the back rest cushions
Lounge and set aside.
2. Raise the bed support
9
3. Pull the lock release strap
4. Slowly and carefully lower the Murphy bed. Ensure
the Murphy bed locks into place once fully lowered
by lifting slightly on the side of the bed. If bed is
not locked, sit on corner of bed to apply additional
downward pressure.
82
from the Rear
7
7 7 7 7
up until it clicks in to place.
8
8
up to release the bed.
9
RAISING THE MURPHY BED
1. Before raising the Murphy bed, be sure to unplug
and remove any devices that may be in the rear
cubby.
ᘐ WARNING
Failure to unplug devices could potentially result
result in a fire if the device overheats.
2. Pull the lock release strap
Murphy bed
10
ᘐ CAUTION
Failure to pull the release strap will cause damage
to the Murphy Bed.
3. Once raised, ensure the Murphy bed is secured by
pulling slightly on the top edge. If bed is not locked
in to place, push firmly along the top edge and test
again.
4. Lower the bed support by lifting slightly, and pushing
upwards in the center of the support
lowering the bed support.
11
UNITY MOTORHOME
, and slowly raise the
10
, and gently
11