Closing The Roof Vent; Adjustments For Day/Night Shades; Adjusting The Tension - Leisure Unity 2020 Owner's Manual

UNITY MOTORHOME

CLOSING THE ROOF VENT

1. Lift the handle to release it from the seat
6
2. Pull down the roof vent using the handle
3. Ensure latch securely locks the handle
5
closed position.
ADJUSTMENTS FOR DAY/NIGHT
SHADES
The spring tension should be accurately set in order to
rewind the material gradually back into the fully rolled
up position. Too much tension in the spring may cause
damage to the shade material.
REMOVING END CAP
1. Reach with your hand between the end cap
the wall as shown in figure
9
2. Push clip away from the wall with your hands still
10
in the same position as figure
3. Pull off end cap .
8
.
7
.
6
in the
6
and
8
.
9
8
.
9
10
APPLIANCE AND EQUIPMENT OPERATION

ADJUSTING THE TENSION

INCREASING TENSION
To increase the spring tension remove the end cap,
and use a flat head screw driver to twist the tension
adjustment screw
11
clockwise until the preferred tension is reached. If there
are two shades in the Impulse Platform, you must modify
the tension individually.
DECREASING TENSION
To decrease the spring tension remove the end cap,
and use a flat head screw driver to twist the tension
adjustment screw
11
counterclockwise until the preferred tension is reached.
If there are two shades in the Impulse Platform, you
must modify the tension individually.
on the left side of the shade
11 11
on the left side of the shade
65