Table of Contents
Advertisement
Charging a disconnected
10
battery
Charge the battery using a
218
suitable charger.
Comply with the operating in-
structions of the charger.
After charging, disconnect the
charger's terminal clips from
the battery terminals.
NOTICE
The battery has to be recharged
at regular intervals in the course
z
of a lengthy period of disuse.
See the instructions for caring
for your battery. Always fully re-
charge the battery before restor-
ing it to use.
Removing battery
Removing seat (
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
with anti-theft alarm (DWA)
If applicable, switch off the anti-
theft alarm.
Switch off the ignition.
ATTENTION
Battery not disconnected in
accordance with correct pro-
cedure
Risk of short-circuit
117).
Always proceed in compliance
with the specified disconnec-
tion sequence.
https://www.motorcycle-manual.com/
OE
First disconnect negative bat-
tery cable 3.
Press in the lock and flip open
positive terminal cover 1.
Then disconnect positive bat-
tery cable 2.
Remove the screws 4 on the
left and right and work the bat-
tery 5 holder forward until clear
of the battery.
Lift the battery up and out;
work it slightly back and forth
if it is difficult to remove.
Installing battery
NOTICE
If the vehicle has been discon-
nected from the battery for a sig-
nificant time, the current date will
have to be entered in the instru-
ment cluster to guarantee correct
operation of the service display.
Advertisement
Table of Contents
