Midi Save; Sustain Switch; Additional Midi Settings On Combination Pistons; Saving Midi Settings On A Combination Piston - Rodgers 835 Manual

Changes made to MIDI settings are temporary and will be lost when the organ is turned
off unless those settings are saved. This is done by performing the following procedure:
 SAVING MIDI CONTROL SETTINGS:
1. While in any MIDI menu, make the desired changes.
2. To save, press and hold the SET piston, then press and hold General Cancel for
approximately five seconds.
3. Continue holding both pistons until the Console Display reads:
4. Release both pistons.
A foot switch is located on the top left edge of the Great/Pedal expression shoe. This
switch will sustain MIDI voices playing from MIDI GT A coupler piston. Press the switch to
sustain, release to stop.

ADDITIONAL MIDI SETTINGS ON COMBINATION PISTONS

After additional MIDI settings have been selected on a MIDI coupler piston, these
settings can be saved on any General or corresponding Divisional combination piston.
 SAVING MIDI SETTINGS ON A COMBINATION PISTON:
1. Select the MIDI coupler piston (and organ stops, if desired).
2. Press and hold the SET piston.
3. Press the desired combination piston.
4. Release both pistons.
The factory default settings for the MIDI coupler pistons are:
* This channel will be different for each MIDI coupler piston. Note: Please refer to the
MIDI channel list at the beginning of the MIDI section.
Remember, MIDI default settings can be changed by performing a MIDI Save procedure.

MIDI SAVE

A L L M I D I
S E T T I N G S S A V E D

SUSTAIN SWITCH

MIDI GT A
Program Change (PGM)
Variation (VAR)
Octave Transpose
Velocity (VEL)
32
= CH 1*
= OFF
= 0
= NORM
= 64