Locking The Crescendo; Restoring The Factory Crescendo Setting - Rodgers 835 Manual

The stops and couplers currently set on stage one of the 63 stages in the Crescendo
sequence turn on.
3. The current sequence may be viewed by advancing through the stages one at a time
using the Alpha Dial. At each stage, the stage number (1 to 63) is indicated in the
Console Display, and the stops and couplers set at this stage turn on.
4. To add one or more stops to the sequence, go to the stage where the stop(s) is to be
added, turn the stop(s) on, and press SET.
5. To delete a stop(s), go to the first stage in which the stop(s) turns on, turn the
stop(s) off, and press SET.
6. Each stop can be turned on at any stage and turned off at any later stage. As an
example, assume the SWELL 8' BOURDON is to turn on at stage 1 and off at
stage 25. Go to stage 1, turn on the SWELL 8' BOURDON, and press SET. Then
go to stage 25, turn off the SWELL 8' BOURDON, and press SET.
7. To clear the entire Crescendo sequence (stages 1 through 63), hold SET and press
General Cancel (0). This also resets the current stage number to 1 so that a new
sequence can be entered.
8. When building a completely new sequence, it is advisable to first write the new
sequence down, then assign stage numbers from 1 to 63 to each stop or group of
stops in the sequence. Sometimes there are more stages than stops in the sequence,
so it is necessary to skip some stages to make the sequence end at or near stage 63.
If this is not done, the sequence ends before the Crescendo Pedal is fully
depressed.
To exit the "CRESC SET MODE" menu at any time, press General Cancel. Any
9.
changes in the sequence made up to this point are saved.
Note: If the original factory setting is desired, please refer to the "Restoring the Factory
Crescendo Setting" section.
 LOCKING THE CRESCENDO:
1. Press and hold the ZIMBEL piston for approximately five seconds until
"CRESCENDO UNLOCKED" appears in the Console Display.
2. While continuing to hold ZIMBEL, rotate the Alpha Dial either direction until the
Console Display reads "CRESCENDO LOCKED."
3. Release ZIMBEL. The Crescendo is locked.
 RESTORING THE FACTORY CRESCENDO SETTING:
1. Press and hold the ZIMBEL piston for approximately five seconds.. The Console
Display reads "CRESCENDO LOCKED" or "CRESCENDO UNLOCKED".
2. While holding ZIMBEL, press and hold SET for an additional five seconds. The
Console Display reads "CRESCENDO FACTORY DEFAULT".
3. Release both pistons.
12