Deleting A Memory From The Card; Storing Crescendo Sequences And Tutti On The Card; Deleting A Crescendo Sequence From The Card; Storing Additional Settings On The Card - Rodgers 835 Manual

 Whenever a memory select piston (M1, M2, M3 or M4) is pressed, a message
appears in the Console Display indicating whether the internal memory or the
Personal Memory Card memory is being used.
 If an internal memory is accidentally copied to the Personal Memory Card, or if a
memory level is to be removed on the Personal Memory Card so the internal
memory can be used instead, you can delete the memory level from the Personal
Memory Card.
 DELETING A MEMORY FROM THE CARD:
1. Hold General Cancel, then press the memory select tab for the memory level to be
deleted.
2. A message will appear in the Console Display confirming the memory level has
been deleted from the Personal Memory Card. Immediately after this operation,
the internal memory will be "reconnected".
STORING A CRESCENDO SEQUENCE AND TUTTI ON THE CARD
In addition to the combination memory levels, the Personal Memory Card can also store
copies of Crescendo sequences and Tutti. If the Crescendo or Tutti set operation is performed
while the card is inserted, the new Crescendo sequence or Tutti will be stored on the card
rather than in the internal memory. Like the combination memory levels, these will
automatically replace the internal Crescendo or Tutti whenever the Personal Memory Card is
inserted in the slot.
The Crescendo and Tutti must be unlocked to delete them from the Personal Memory
Card.
 DELETING A CRESCENDO SEQUENCE FROM THE CARD:
1. Press the ZIMBEL piston.
2. Hold General Cancel, then press ZIMBEL again. A message appears in the
Console Display confirming deletion of the stored Crescendo sequence or Tutti
from the Personal Memory Card.

STORING ADDITIONAL SETTINGS ON THE CARD

Several additional settings can also be stored on a Personal Memory Card. Changing any
of these settings causes all of them to be moved to the card if they were not previously stored
on the card. The settings will automatically take effect when the card is inserted. The settings
are:
* Melody Note Range
* Bass Note Range
* Wind Stabilizer Status
* Expression Range Settings
 DELETING SETTINGS FROM THE CARD:
* Master Tuning Lock Status
* Tremulant Adjustments
* Console Lamp Intensity
* MIDI Stop Change Send/Receive Enable
*Voice Palette Selections
39