Setting The Pistons; Locking A Combination Memory - Rodgers 835 Manual

 SETTING THE PISTONS:
1. Select a memory by pressing M1, M2, M3 or M4. Note: Pistons cannot be set if
the memory is locked. Please refer to the "Unlocking a Combination Memory"
section.
2. Select the desired stops.
3. Press and hold the SET piston, located under the Great manual to the far left.
4. While holding SET, press the desired combination piston. Then release both
pistons.
Note: Stops may be added or deleted from any combination using the above procedure.
 LOCKING A COMBINATION MEMORY:
Press and hold M1, M2, M3 or M4 for approximately five seconds. "USING
1.
INTERNAL MEMORY" or "USING CARD MEMORY" appears in the Console
Display first. Then "MEMORY (#) UNLOCKED" appears.
2. While continuing to hold the memory piston, rotate the Alpha Dial either direction
until the Console Display reads "MEMORY (#) LOCKED."
3. Release the memory piston. The memory is now locked.
5