Fluke FI-3000 FiberInspector Pro User Manual page 17

Inspect an Endface
1. Insert the probe tip into a bulkhead connector, or into an
adapter attached to a patch cord (Figure 8).
The app shows a live image of the endface. You can adjust the
image as shown in Figure 9.

2. Press
Test on your mobile device.
3. When the LEDs on the probe show the pass ( ) or fail ( )
result, you can remove the probe from the connector.
4. After the probe transmits the test results to your device, the
app shows the TEST RESULT SUMMARY screen. You can then
Save or Share the result or tap the endface graphic to see
detailed results. See "Endface Image Screens" on page 17.
To see the live image again, tap
Patch cord
Adapter*
* The adapter's key position affects the fiber numbers
in your test results. See "Set the Key Position" on
page 13.
to focus the image if necessary, then press
Figure 8. Inspect an Endface

or Live.

or tap
CL04.PDF
15