Advertisement
Step 2.
Install the
Tool is a software utility used to "discover" cameras and NVRs/DVRs installed on the physical
Ethernet network (LAN) and change their network settings.
To use Discovery Tool:
1.
your camera on the LAN.
2.
the folder that contains the
3.
Install
Tool.
In the example screen shown above, otice that the IP address of the camera is 192.168.1.64
(default IP address). This camera, although configured for a subnet that is probably foreign to the
network it is installed on, is still found by the tool.
5.
To change the network settings of the camera to be compatible with the subnet where it is installed,
do the following:
a.
Click on the device to highlight it. Notice that the network parameters for the device populate
b.
Modify the network settings to values compatible with the subnet where it is installed:
If the IPv4 Address shown for the camera is 192.168.1.64 (default IP address) and the
»
a DHCP server on the network. Modify the parameters in the right pane to values you
prefer and are compatible with the network. An example is shown in the screen below.
2
www.larsonelectronics.com
Tool
Tool is provided
on Microsoft Windows computer you will use to access
.
If the IPv4 Address shown for the camera is something other than 192.168.1.64 (default
»
IP address) and
camera
are compatible with the network. If necessary, change the parameters in the right pane to
values that you prefer and are compatible with the network. An example is shown in the
screen above.
Enter the admin password for the camera in the Password field. The default admin user
c.
password for cameras is
Click the Modify button. The new IP address, port, and other settings will change and
d.
by clicking the Close icon (
6.
Close the
did not
a DHCP server on the network and acquired new network parameters that
) in the upper-right corner of the screen.
Advertisement
