Step 5: Record Results; Step 6: Prepare For New Patient; U Sing A Dview 2 F Or H Eart R Ate; Measurement - ADC ADView 2 User Manual

Example of SYS, DIA and HR* after
BP measurement in Single
Measurement Mode.
*Note: Pulse rate source, whether BP or SpO
Application. The default setting uses BP as HR source. If used outside of the United States, the device also can
be configured to measure MAP using the Configuration Application. If set up to measure MAP, the MAP and HR
measurements will alternate in 3-second intervals. NOTE: MAP is not available in the U.S.
Step 5: Record Results
When the measurement cycle is complete, values will be displayed for systolic and diastolic pressure, plus heart rate
if BP is selected as the pulse rate source. Manually record, print and/or digitally save your measurements according
to your healthcare facility's preferred process. To send results to an EMR or to the device memory, follow the steps in
Section 4.

Step 6: Prepare for New Patient

After all measurements have been recorded or captured, remove the cuff from the patient and clean it according to
your facility's requirements. This disinfecting and storage step applies to BP cuffs as well as other optional
accessories whose use will be covered in the following sections.
Pressing the Memory Button
saving the patient and measurement information in memory. It is recommended that the display is cleared before
taking readings on a new patient.
6. Using ADView 2 for Heart Rate Measurement
There are two ways to measure heart rate with the ADView 2.

BP Heart Rate Measurement

With this method, HR is captured automatically during BP measurement.
SpO Heart Rate Measurement
2
If you have the optional pulse oximetry module on your device, you can measure HR through the SpO
next section (section 7) for more on use of this option.
The ADView 2 uses BP as the default HR source. HR source can be selected using the Advanced Configuration
Application.
93-9005-00
September 1, 2016
Example of SYS, DIA and HR* after
all measurements have been
averaged.
, can be selected at any time using the Advanced Configuration
2
will clear all patient and measurement data from the display, in addition to
Example of Manual Mode display
with cuff pressure at zero. P-set
value is default 160 mmHg.
sensor. See
2
ADView 2 User Manual | 25