Advertisement
5. Unscrew knob on left solenoid and remove solenoid
from shaft, pulling out the two wires with it. See F
3.
F
. 3: Solenoid Removal
IG
6. Remove clip on elbow connector using small flat
screwdriver and pull flex tube with three harness
wires out of directional valve (see F
for reinstallation.
Clip
F
. 4: Harness Removal
IG
311341A
7. Loosen brass fitting on elbow connection using an
.
IG
F
. 5: Connector & Valve Removal
IG
. 4). Save clip
IG
8. Remove old directional valve by removing four
9. Clean manifold mating surface of all dirt and debris.
open-end wrench. Also remove elbow connector.
See F
. 5. Save connector for reinstallation.
IG
socket head cap screws with hex key (have an
appropriate waste container and rags handy to
catch any dripping hydraulic fluid). See F
Do not allow any dirt into ports.
Old Valve Removal
. 5.
IG
3
Advertisement
