Advertisement
New Valve Installation
1. Install new directional valve as follows (see F
a. Turn valve upside down. Pull out and discard
clear plastic plug.
b. Ensure the four o-rings are in place.
c. Mount valve using the four new 2 in. socket
head cap screws provided in kit. Tighten screws
firmly using hex key.
Discard
Check O-rings
F
. 6: New Valve Bottom
IG
4
. 6):
2. Unscrew knob on left solenoid and remove solenoid
IG
from shaft. Do not loose the three o-rings (see F
7).
O-rings
F
. 7: Connector Installation
IG
3. Remove and discard threaded plug from hole in new
valve.
4. Install elbow connector and tighten brass fitting on
connector using open-end wrench.
5. Reinstall solenoid and knob removed in Step 2.
New Valve Installation
Discard
O-rings
.
IG
O-rings
311341A
Advertisement
