Fisher & Paykel ACTIVESMART RF523G User Manual / Installation Manual page 21

What to do if your product is unstable
Gently push the refrigerator back until the rear
A
rollers contact the floor.
Measure the gap under the front foot, which has
● ●
come off the floor.
Obtain some solid packing material (hardwood,
● ●
plastic, etc) which fits firmly into the gap
under the foot.
Note: Do not use metallic materials that may
corrode, stain and/or damage floor coverings.
Wind both front feet up and roll the product
B
out of position.
Place the packing material in the location
● ●
diagonally opposite the front roller that
lifts off the floor.
Make sure the packing material stays in place
● ●
when the product is pushed back into position.
Ideally, the packing material is large enough
● ●
to rest against the back wall to prevent it from
moving when the cabinet is pushed into position.
Wall behind refrigerator
Roll the refrigerator back into position and adjust front feet as per step
C
(check alignment and door closing action are satisfactory).
Make small adjustments to front feet where necessary.
● ●
Check that the product is stable (all four feet are on the floor). If not,
● ●
repeat and
A
INSTALLATION INSTRUCTIONS
For example: if this foot lifts off the floor when
pushing gently on the top front of the refrigerator
.
B
This foot lifts off the floor when
top front is gently pushed back
Packing material goes under rear roller
diagonally opposite front foot that lifts
Stabilising your refrigerator
Example only
Unlevel floor
on page 18
C
19