Fisher & Paykel ACTIVESMART RF523G User Manual / Installation Manual page 20

Positioning your refrigerator (all models)
Your Fisher & Paykel ActiveSmart™
refrigerator is fitted with front and rear
rollers to allow you to easily move your
refrigerator forward and backward.
Avoid moving your refrigerator sideways
to prevent damaging the rollers or the
floor covering surface.
Your refrigerator will arrive with the front feet wound up making moving the product
A
into its final location a simple task.
Roll the refrigerator into its final position making sure there is the correct air gap
B
between the product and surrounding cabinetry. See minimum clearance in cabinetry
dimensions table.
Adjust the front feet down until the refrigerator is leaning backward with the front
C
approximately 10mm higher than the back. This will ensure a good door closing action.
(Non French door models only)
Aligning your refrigerator with cabinetry.
D
Align the sides of the refrigerator with the cabinetry by adjusting the hinge
● ●
side front foot.
Adjust the handle side foot until it touches the floor and takes a small amount of weight.
● ●
Once the refrigerator is in place and aligned with cupboards/alcove gently push on
● ●
the front top and check if the product is rocking or stable.
Levelling of refrigerator doors
Open the door that is out of alignment.
● ●
Lift the door upwards.
● ●
Clip the spacer onto the centre hinge
● ●
pin (refer to A).
Close the door to recheck alignment.
● ●
18
INSTALLATION INSTRUCTIONS
Lower the front of
the refrigerator
Refrigerator feet
Raise the front of
the refrigerator
A