Ts2 Cable Fuse Replacement; Ts2 Battery Replacement - Honeywell Temaline TS2 Installation Manual

32
https://extranet.honeywell.com
DL4 = OFF
Table 9 - Application quick health checks

TS2 Cable Fuse replacement

One of the wires for the battery connection has a fuse embedded.
If you need to replace this fuse, you must:
1. Have the proper spare part: Fuse F1: 3A 250V delayed
(5X15 UL Omega) wired.
2. Replace the cable
3. Verify if the battery wires are connected with the right
polarity.

TS2 Battery replacement

The battery has to be replaced every 3 years. There is no need to
check the status of the battery as it is automatically checked by
the software application.
To replace the battery follow these steps (see Figure 23):
1. Switch the unit OFF
2. Unscrew the two special lateral screws that secure the
cover. This operation requires a TORX anti-tamper T10
screwdriver.
3. Unscrew the battery plastic fixing.
4. Disconnect the battery leads pulling the wire terminals
connectors.
5. Replace the battery with the spare one (6V 1.2 Ah)
6. Connect leads to the battery terminals. Be sure about the
polarity (red=+, black=-).
If DL5 steady ON No RTUs configured.
Configure the RTUs
If DL4 = ON The TS2 LonWorks Xboard is
LonWorks MIP broken and it must be
without application substituted.
and not configured
If DL4 = blinks
LonWorks MIP has
the application but
it is not configured