Ts2 Main Board - Switches And Leds - Honeywell Temaline TS2 Installation Manual

TS2 Main board - Switches and LEDs

Switch Function
SW3 Microprocessor Reset or Power OFF, for disconnect the
battery, after 12VDC main supply removing
SW4 Power ON from battery when is needed powered the
TS2 without the 12VDC main power source (limited time)
Jumper Function
JP1 Flash memory Boot space protection
Close = boot protected (Only read mode)
Open = boot read / write mode
J6 CPU debug jumper – have to be OPEN
LED Function
CR2 +12VDC main power LED - Green
ON = +12VDC present
OFF = +12VDC not present
23
- +
Default
state
OFF
OFF
Default
state
CLOSE
OPEN
Default
state
ON