Table of Contents
Advertisement
Installing the AppController
Installing the AppController
Mount the controller (page 4).
1
Wire the controller for power (page 5).
2
Set the controller's address (page 5).
3
Wire the controller to the BACnet MS/TP or BACnet ARC156 network (page 6).
4
Wire inputs and outputs. (page 7)
5
Wire devices to the controller's Rnet port (page 12, page 11).
6
Mounting the AppController
WARNING
When you handle the AppController:
• Do not contaminate the printed circuit board with fingerprints, moisture, or any foreign material.
• Do not touch components or leads.
• Handle the board by its edges.
• Isolate from high voltage or electrostatic discharge.
• Ensure that you are properly grounded.
Screw the AppController into an enclosed panel using the mounting slots on the coverplate. Leave about 2 in. (5
cm) on each side of the controller for wiring. Mounting hole dimensions 5 9/16" (14.1 cm) between mounting slot
center lines.
AppController
Installation and Start-up Guide
4
CARRIER CORPORATION ©2019
All rights reserved
Hide quick links:
Advertisement
Table of Contents
