WimTec PROOF S4 Assembly And Operating Instruction page 15

PROOF S4
Assembly
7
10
7. Feed the 0,5 mm
2
the power supply (art. no. 117 899, 113 792).
Attention: The power supply must not be installed in the flush-mount set!
HINT: to deactivate the shower for cleaning purposes we advise to install a switch
(key switch) ahead of the power supply!
8. Correctly align the mounting frame and securely fasten the screws. When tightening the
screws, ensure that the mounting frame does not get warped. Apply the included special
grease to the front of the valve.
9. Plug in the magnetic valve and connect the power cables to the electronics module.
10. Check the thermostat position (turn the thermostat shaft to the leftmost position, and then
turn it to the right until the arrow points upwards). Switch on the power supply (causing the
safety locking mechanism of the magnetic valve to activate).
11.
Apply the included special grease to the front of the valve.
8
11
or 2 x 1 mm connection cable into the flush-mount set and connect it to
2
9
WimTec PROOF S4
Shower control
EN
15