Nortel Meridian 1 Manual page 32

Page 32 of 86 Operation procedures and tests
Procedure 11
Keyboard dialing from colocated ADM (QMT8) data station (Part 4 of 4)
Step Action
Call disconnect procedures
21 Enter a disconnect command to terminate session and to initiate call disconnect by the
host (for example, use disconnect commands such as Logo or Control + D). This
causes the called terminal to disconnect the call by dropping DTR.
or
Operate terminal LINE or POWER switch to OFF.
or
Operate DS and RLS keys in sequence.
22 Call
disconnected.
Note 1: Speed Call, Hot line, Autodial, Call Forward, and Ring Again can only be programmed with the
DATA SHIFT key (DS) and the relevant feature keys of the SL-1 set.
Note 2: If the called port is busy, the Meridian 1 system returns a busy tone. When Ring Again is activated
by the SL-1 set, the Y answer to the screen prompt causes the ADM to retry the call.
Note 3: If the user wants to abandon the call during the call setup stage, press CONTROL + Z.
Note 4: During call setup, there is a maximum number of characters in a line. The ADM ignores all
characters entered beyond this limit.
Note 5: If a data call is being set up and you receive a voice call is received, answer the voice call and then
put it on hold. Release the data call with CONTROL + Z if necessary.
Note 6: If a remote terminal is calling into an inbound modem pool and is calling multiple hosts, the ADM
serving the modems must be set up in the non-hot line mode and the caller must enter the DN of the called
host (steps 12 and 13). If the remote is calling a single host, the ADM serving the modem must be set up in
the Hot Line mode with the DN programmed to the DN of the called host (skip step 13).
553-2731-300 Standard 4.00 April 2000
Verification
DDN and DATA SHIFT lamps
off.
Comment
CALL RELEASED appears on
screen.
All ADM lamps except POWER
go dark.