Low surface temperature panel heaters with intelligent fan control & electronic 7-day timer (7 pages)
Summary of Contents for Heatstore HSCF3000E
Page 1
3kW Low Level Fan Heater with Electronic Controls and Open Window Detection Installation & Control Guide HSCF3000E All electrical appliances produced by the company are guaranteed for two years against faulty materials or workmanship. This applies only if the appliance has been used...
Page 2
Overview Ensure that the appliance is functioning Please read this guide carefully and retain for correctly. If not, the appliance should be future use and maintenance. checked by a competent electrician. This appliance has been designed and The heater carries a ‘Do Not Cover’ label manufactured to the highest international to warn the user that if the appliance is standards, however, care must be taken for...
Page 3
Connection to the Main Supply 1. Mounting Electrical installation should be carried out This unit is for wall mounting only. It is by a competent installer, preferably designed to be very quiet in operation if registered with NICEIC (National mounted correctly. When fitting more than Inspection Council Electrical...
1.1 Mounting Installation Figure 1. - HSCF3000E dimensions OPTIMUM MOUNTING HEIGHT IS 400mm FROM THE FLOOR. NOTE: - MINIMUM CLEARANCE FROM THE FLOOR IS 200mm. - IF THE HEATER IS MOUNTED AT HIGH LEVEL, THE MINIMUM DISTANCE FROM THE CEILING IS 1000mm.
Page 5
The cycle sequence will always start with BOOST mode followed by MANUAL, SETB and PROG. The HSCF3000E also has a STANDBY MODE. To enter/exit this mode, press the standby button. In STANDBY MODE, the heating will not be activated.
Page 6
9. Setting the time and day temperature - allowing for almost The HSCF3000E will come set with the silent operation. correct time and day. It has an internal battery back up that can remember the settings.
Page 7
13. Setting the automatic program schedule An example of one day program on HSCF3000E PROGRAM 1 PROGRAM 2 PROGRAM 5 PROGRAM 6 ºC PROGRAM PROGRAM 19ºC 22ºC 22ºC 16ºC 10ºC 4ºC 06:00 08:00 12:00 14:00 16:00 22:00 Step 4: Press the MENU button.
Page 8
Alternatively, it is possible to copy a 14. Overview of program mode program from one day to another. The HSCF3000E has a 7-day, 5-day + 2-day To do this, follow the steps below; and a 24 hour timer available. This can be chosen in the setup menu.
Page 9
18. Setup Menu Press and hold MENU and - together for 5 7 - Temperature drop seconds. in open window The display will enter the setup menu. detection time Use + and - to change a value. Use MENU to scroll between the settings. Use standby button to exit the setup 8 - Closed window menu.
Need help?
Do you have a question about the HSCF3000E and is the answer not in the manual?
Questions and answers