Fixture Installation - B-K lighting MINI-MICRO DRIVESTAR Installation Instructions

Soil Prep
A. Determine Soil Type by referencing DIG-IT Guide.
Prep soil according to DIG-IT Guide.

Fixture Installation

Finished grade
8 3/4"
1. Excavate trench according to designed lighting
plan 10" deep and 10" wide suitable for the 8-3/4"
fixture housing.
2. Supply low voltage wiring necessary for
installation (By Others).
2 window
faceplate
shown
Optical opening on
faceplate will align with
alignment arrows on
temporary cover
5. Place Power Pipe™ in hole.
NOTE: Leave sufficient wire length in the LINE
12V
Remote
Power Pipe™ for future service.
Transformer
COM COM
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
B-K LIGHTING
Finished grade
Surface Mount Installation
Conduit
trench
B. Dig hole 10" wide and 10" deep.
Finished grade
Finished grade
3. Slide stability flange onto Power Pipe™.
NOTE: Product is supplied with a stability
flange to anchor fixture and aid i n installation.
Rebar or stake (by others)
Do not cut Power Pipe™ . Doing so will
2 window
prevent sufficient wire makeup for fixture
Finished grade
faceplate
service and will void warranty.
shown
Optical opening on
2 window
faceplate will align with
faceplate
alignment arrows on
shown
temporary cover
Optical opening on
faceplate will align with
alignment arrows on
temporary cover
6. Align holes to final installation orientation. Point
arrows on temporary cover toward surface to be
LINE
Remote
illuminated.
Transformer
NOTE: Do not remove temporary cover until
FIXTURE
installation of faceplate.
COM
LINE
40429 Brickyard Drive • Madera, CA 93636 • USA
COM
www.bklighting.com • info@bklighting.com
Rebar or stake (by others)
Finished grade
Finished grade
MINI-MICRO ™ DRIVESTAR™
PROJECT:
TYPE:
8 3/4"
8 3/4"
Stability flange
Concrete
Pea gravel or sand
12V
FIXTURE
COM
12V
Remote
Transformer
FIXTURE
COM
559.438.5800 • FAX 559.438.5900
Stability flange
Concrete
Excavated
for Housing
C. Prep soil according to DIG-IT Guide.
4. Loop minimum of 6" of low voltage wire inside
Power Pipe™ to allow for fixture service.
NOTE: Do not remove temporary cover!
Rebar or stake (by others)
Stability flange
Concrete
Finished grade
Pea gravel or sand
Rebar or stake (by others)
Rebar or stake (by others) Stability flange
Concrete
Finished grade
Concrete
Finished grade
Pea gravel or sand
7. Back fill with pea gravel or sand prior to pour.
NOTE: The Power Pipe™ must be flush to
finished grade. Use stability flange to aid in
installation of Power Pipe™ as shown.
RELEASED REFERENCE NUMBER
11-21-16 INS001068.1
Rebar or stake (by others) Stability flange
Concrete
Finished grade
2 window Pea gravel or sand
Conduit
Trench
Stability flange
Pea gravel or sand
2 win
facep