Operation Guide; Replacement Of Batteries In Remote Controller - Viking GWH12UB Owner's Manual

Operation guide

1.
After putting through the power, press "ON/OFF" button on remote controller to
turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT.
3.
Press "+" or " - " button to set your required temperature. (Temperature can't
be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low, medium and high
speed.
5.
Press " " button to select fan blowing angle.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
Battery level will be displayed on the remote
controller hen "
replace the batteries, otherwise, remote
controller can't operate normally.
NOTICE
window on indoor unit.
The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
Signal may be interfered easily in the room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit during
operation.
batteries.
replace batteries.
" is flickering, please
ntrol signal sender at the receiving
16
signal sender
reinstall
Cover of battery box
s no display, please
battery
remove
battery level