Viking GWH12UB Owner's Manual page 17

Introduction for buttons on remote controller
12
/
button
Press this button to activate health function with "
the second time to activate health and air in function with "
press this button for the third time to activate health and air out function with "
" " displayed; press this button for the fourth time to activate air in function with
" " displayed; press this button for the fifth time to activate air out function with "
displayed; press this button for the sixth time to exit health, air in or air out function.
13
TEMP button
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit's display. The setting on
remote controlleris selected circularly as below:
on indoor unit displays set temperature.
displays indoor ambient temperature.
displays outdoor ambient temperature.
Note:
Outdoor temperature display is not available for some models. At that time, indoor
unit receives "
's defaulted to display set temperature when turning on the unit.There is no
display in the remote controller.
temperature indicator displays corresponding temperature and automatically turn
14
X-FAN button
Pressing this button in COOL or DRY mode, the icon "
fan will continue operation for 2 minutes in order to dry the indoor unit even though you
have turned off the unit. After energization, X-FAN OFF is defaulted. X-FAN is not
available in AUTO, FAN or HEAT mode.
no display
" signal, while it displays indoor set temperature.
" displayed; press this button for
r, temperature indicator on indoor unit
r, temperature indicator on indoor unit
outdoor ambient temperature, indoor
12
" and " " displayed;
cancel
r, temperature indicator
y.
" is displayed and the indoor
" and
"