H3C S5560S-SI Installation Manual page 99

Mode LED status
Flashing green (PoE
mode) (available only
for PoE switch
models)
Flashing yellow (IRF
mode)
Table 39 10/100/1000BASE-T autosensing Ethernet port LED description
Mode LED status
Steady green
(Link/Active mode)
Flashing yellow (IRF
mode)
Table 40 10/100BASE-T autosensing Ethernet port LED and 10/100/1000BASE-T autosensing
Ethernet port LED description
LED status
Steady green
Flashing green
Off
10/100BASE-T
autosensing Ethernet port
or 10/100/1000BASE-T
autosensing Ethernet port
LED status
Off
Steady green
Flashing green (1 Hz)
Off
Steady green
10/100/1000BASE-T
autosensing Ethernet port
LED status
Steady green
Flashing green
Off
Steady green
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
91
Description
No link is present on the port.
PoE power supply is normal.
•
The maximum PoE power provided by the
port fails to meet the power requirement of
the PD.
•
PoE power supply overcurrent, overvoltage,
or short-circuit occurs.
•
The remaining power of the switch fails to
meet the power supply requirement of the
port.
The port is not connected to a PD or PoE is not
enabled on the port.
The 10/100/1000BASE-T autosensing Ethernet
port LEDs on the switch work in conjunction to
indicate the IRF member ID of the switch. For
example, if the LED for port 5 is steady green and
the other port LEDs are off, the IRF member ID of
the switch is 5.
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
The 10/100/1000BASE-T autosensing Ethernet
port LEDs on the switch work in conjunction to
indicate the IRF member ID of the switch. For
example, if the LED for port 5 is steady green and
the other port LEDs are off, the IRF member ID of
the switch is 5.