Chapter 2. Installing The Adapter Hardware; Installing The Adapter; Selecting Adapter Cables - IBM 16/4 User Manual

Chapter 2. Installing the adapter hardware

This chapter describes how to install the IBM 16/4 Token-Ring Low Profile PCI
Management Adapter.

Installing the adapter

Your adapter comes configured from the factory with PXE and expansion ROM
enabled.
Before you begin to install this adapter, be sure to read "Safety Information" on
page 47.
To install your adapter, perform the following procedure:
10. The hardware installation is complete. See "Chapter 3. Software installation" on

Selecting adapter cables

To connect your adapter to a token-ring network, you will need either of the cables
shown in Figure 1 on page 6. The network end of the cable must be compatible with
the network faceplate or other device to which the adapter will be connected. The
cables are not included with the adapter.
© Copyright IBM Corp. 2000, 2001
1. Switch OFF the PC and all attached devices.
Note: In the U.K., by law, telephone line cables must be disconnected from
the PC before the power cord.
2. Remove the power cord from the outlet.
3. Remove all cables from your PC. Label each cable for easier reconnection at
the end of this procedure.
4. Follow the instructions provided in your PC manual for removing the cover or
otherwise accessing the adapter slots and inserting the adapter.
5. Install the adapter according to the instructions for adapter installation in the
manual that came with your PC.
6. Secure the adapter in the PCI slot with the retaining screw or other bracket
lockdown mechanism.
7. Reinstall all removed covers.
8. Connect the token-ring cable to the adapter and to the network. See "Selecting
adapter cables" for a description of the correct token-ring cables to use.
9. Reconnect all cables to your computer and then connect the power cord.
Follow all safety instructions.
Note: In the U.K., by law, the power cord must be connected before the
telephone line cable.
page 7.
5