IBM 16/4 User Manual page 18

10. Select the Update driver... button to open the Update Device Driver Wizard.
11. Select Next to continue.
12. On the next page, select Search for the best driver for your device and
13. The next page of the wizard will ask where you would like to look for the
14. Select Next to continue. Make sure that driver you want updated is displayed
15. The next page of the wizard should confirm that the hardware and device
16. Select Finish to continue.
17. Select Yes when asked to reboot the system.
18. Check for the following conditions to determine whether the adapter is working
12
IBM 16/4 Token-Ring Low Profile PCI Management Adapter
9. Select the Driver tab.
then select Next.
device driver.
v If you are installing from a diskette, insert the diskette and make sure that
the Floppy disk drives checkbox is checked.
v If you are installing from a location on your hard drive, make sure that the
Specify a location checkbox is checked.
on on the screen and select Next.
Note: If the wizard does not specify the correct driver location, for example
the CD-ROM or diskette drive, perform the following steps:
a. Click the Back button twice.
b. Select Display a list of known drivers . . . and then select Next.
c. Select Have Disk. . . and then specify the location of the driver (the
CD-ROM or diskette drive letter).
d. After you select the correct driver, an Update Driver Warning
window might appear. If so, click Yes to continue.
driver are found. Select Next again to begin copying files.
Notes:
a. Windows might prompt you for the driver diskette. If so, type the letter of
your drive.
b. Windows might also prompt you for the Windows 2000 CD-ROM in order
to install its default network protocols. Make sure that the location of your
Windows 2000 installation files (for example, d:\ or d:\win2000 or
c:\windows\catroot) appears in the entry and select OK.
c. A Digital Signature Not Found window might appear saying that the driver
is not digitally signed. If so, select Yes to continue.
After the files are copied, the wizard displays a message to inform you that the
driver was installed.
correctly and whether installation has been completed successfully:
v The device driver files loaded successfully.
v The Local Area Connection icon on the Network and Dial-up Connections
window shows that the device is working correctly.
v The adapter LEDs indicate normal operation: Green ON, Amber OFF.