Mopar 82215863 Manual

Soft folding truck bed cover

82215863 - 5' 7" truck bed

82215864 - 6' 4" truck bed

STANDARD BED INSTALL

1.0 COVER PLACEMENT

Place the cover onto the truck bed

1.1

rails and bulkhead.

NOTE:

Take care not to damage or

deform the cover seals

while installing the cover.

NOTE: When placing

the cover onto the

bulkhead, make sure

the cover cab seal

fully contacts and seals

to the top of the

bulkhead.

August 20, 2018

Soft Folding Truck Bed Cover

Standard Bed Install

www.mopar.com

K6862996

Table of Contents

Do you have a question about the 82215863 and is the answer not in the manual?

Page 1 Soft Folding Truck Bed Cover Standard Bed Install www.mopar.com 82215863 - 5’ 7” truck bed 82215864 - 6’ 4” truck bed STANDARD BED INSTALL 1.0 COVER PLACEMENT Place the cover onto the truck bed rails and bulkhead. NOTE: Take care not to damage or deform the cover seals while installing the cover.
Page 2 STANDARD BED INSTALL 2.0 COVER LATCHING at the FRONT/CAB END. Swing the cab clamps (1) down from the stowed position and slide them toward the truck bed rail. Swing the clamps so the clamp jaw is under the truck bed rail.
Page 3 STANDARD BED INSTALL 3.0 COVER LATCHING at the REAR/TAILGATE END. Close the tailgate and unfold the cover. Check that the cover is parallel and square with the truck bed and bed rails. If not parallel or square, open the cover and loosen the cab clamps to reposition the cover.
Page 4 DRIVING WITH THE BED COVER For driving with the cover open, both cab clamps must be secured, and both straps must be latched. When driving with the cover closed, both the pair of cab clamps and the pair of tail clamps must be secured.
Page 5 NOTE ! Tighten the clamps after the ﬁrst week of driving with the cover, and periodically check all clamps for a secure ﬁt. OWNER/USER RESPONSIBILITES It is the responsibility of the owner/user to read this manual and comply with the operating procedures.

82215864