Filter & Floater; Self-Cleaning Function - Fakir Starky WDA 700 Wet & Dry User Manual

Filter & floater
A
B
C
Brush roll self-cleaning
38
Cleaning and maintenance
The Pre-filter (A) is located in the lid of the dirt water
tank. Open the lid, g Grasp recessed area on each
side of the pre-filter and pull upward to remove, then
rinse with water.
Let it dry out before placing back into the lid of the dirt
water tank. In the case of heavy soiling replace the
filter.
If the filter (B) and the floater (C) have been blocked,
they have to be cleaned. Take off the filter from the
tank lid, pull out the floater, and rinse them with water.
Let it dry out completely before putting back into
place.
For optimal performance, use the quick self-cleaning
fuction as often as needed.
Please empty the dirt water tank before and after
self-cleaning. Place unit on storage tray. The clean
water tank should be at least 1/3 full of water. Press
and hold the "ON" button for 3 seconds to start the
brush roll self-cleaning mode.The appliance will auto-
matically shut off after it is finished.
The entire self-cleaning process takes about 40 sec-
onds.