Table of Contents
Advertisement
1
Overview
The SI-T/V7 Interface Unit is an interface unit that connects to the MECHATROLINK-I or
MECHATROLINK-II high-speed field network for communicating with the host controller.
By installing the SI-T/V7 Unit to a VS-606V7-series Inverter, various applications are enabled;
monitoring of the run/stop status and the operating conditions as well as the changing and the
referencing of the settings for the Inverter constants from the host controller.
The SI-T/V7 Unit can be installed in the following Inverters.
VS-606V7 Inverter with an SI-T/V7 Unit does not conform to CE Marking, although the VS-606V7
IMPORTANT
Inverter itself conforms to CE Marking.
2
Checking the Product
Check the following items as soon as the product is delivered.
Is there any discrepancy between the shipment and
what was ordered?
Has the product been damaged in any way?
Are the contents of the package correct?
Contact your Yaskawa representative immediately if any failure should be found concerning the
above items.
2.1
Nameplate
The following diagram shows the nameplate on the side of the SI-T/V7 Unit.
• VS-606V7-series Inverter, software No. 5650.
• VS-606V7-series Inverter, software No. 573X.
Note: 1. "X" indicates the design revision order.
2. The Inverter software will soon be updated from version No. 5650
to No. 573X.
Item
SI-T/V7 Unit type
Code No.*
Program No.
Lot No.
Manufacturing No.
* "X" indicates the design revision order.
Check the information printed on the Unit. (Refer to 2.1.)
Inspect the entire exterior of the Unit for any damage that
may have occurred during shipping.
Check the contents shown in the table below.
INTERFACE UNIT SI-T/V7
CODE NO : 73606-V706X
PRG
:
LOT NO :
SER NO :
YASKAWA ELECTRIC
CORPORATION
9
1 Overview
Method
MASS : 0.5kg
Mass
M S
MADE IN
JAPAN
Advertisement
Table of Contents
