Table of Contents
Advertisement
Chapter 2
Hardware Configuration and Installation
This chapter contains the instructions to configure and install the VME-SB2020 interface kit.
The instructions are given in the order that you should perform them. A summary of the steps is
as follows:
1. Unpack the SB-MXI and VME-MXI.
2. Install the SB-MXI hardware.
3. Configure the VME-MXI hardware.
4. Install the VME-MXI hardware.
5. Connect the MXIbus cable.
Step 1. Unpack the SB-MXI and VME-MXI
Follow these steps when unpacking your SB-MXI board and VME-MXI module:
1. Before attempting to configure or install the SB-MXI and VME-MXI, inspect the shipping
container and its contents for damage. If damage appears to have been caused in shipment,
file a claim with the carrier. Retain the packing material for possible inspection and/or for
reshipment.
2. Verify that the pieces contained in the package you received match the kit parts list. Do not
remove the boards from their plastic bags at this point.
3. Your SB-MXI board and VME-MXI module are shipped packaged in antistatic plastic bags
to prevent electrostatic damage. Some of the circuitry on the SB-MXI and VME-MXI use
CMOS technology and can be damaged by electrostatic discharge. Before removing the
boards from their antistatic bags, touch the bags to a metal part of your computer chassis.
4. As you remove the SB-MXI and VME-MXI from their bags, be sure to handle them only by
their edges. Avoid touching any of the IC components or connectors. Inspect them for loose
components or any other sign of damage. Notify National Instruments if either board
appears damaged in any way. Do not install equipment that appears to be damaged.
© National Instruments Corporation
2-1
VME-SB2020/NI-VXI/Solaris Getting Started
Advertisement
Table of Contents
