Table of Contents
Advertisement
Chapter 2
Hardware Configuration and Installation
6. Align the SBus connector plug of the SB-MXI with the SBus socket and gently press the
plug into the socket.
7. Check the installation.
8. Replace the cover to the system unit.
Figure 2-1 shows an SB-MXI installed in a SPARCstation 1+.
Art not available in PDF version of document.
Figure 2-1. SB-MXI Installed in a SPARCstation 1+
© National Instruments Corporation
2-3
VME-SB2020/NI-VXI/Solaris Getting Started
Advertisement
Table of Contents
