Table of Contents
Advertisement
Avaya 3100 Mobile Communicator Gateway installation and
commissioning
Installation and commissioning of the Avaya 3100 Mobile Communicator Gateway is performed
by Avaya personnel. For information, see Installation Method, 24-2786.
Avaya Communication Server 2100 configuration
This section describes the configuration required on the Avaya Communication Server 2100
(avaya CS 2100).
Service DN configuration
The mobile clients use a Service DN to originate calls in direct outbound mode. The Service
DN information for the trunk between the Avaya 3100 Mobile Communicator Gateway and the
SIP PBX interface on the Avaya Communication Server 2100 must be set up.
The Service DN information on the Avaya CS 2100 is datafilled in tables DNROUTE and
IBNROUTE. The following example shows the datafill to use (references to the specific entry
in table IBNRTE and to the trunk CLLI are site-dependent):
>table dnroute TABLE: DNROUTE >pos 972 684 9120 972 684 9120 T IBNRTE
920 >dow 972 684 9121 T IBNRTE 921 >table ibnrte TABLE: IBNRTE >pos
920 920 ( N N N N N SIPPBX2MC31002 0)$ $ >pos 921 921 ( N N N N N
SIPPBX2MC3100 0)$ $
The Service DN information for the Avaya 3100 Mobile Communicator Gateway is set up using
the Dial-In Service DN on the Avaya 3100 Mobile Communicator Gateway. Additionally, the
User Name and Password must match the Dial-In Service DN, as shown in the following
examples.
Configure the Dial-In Service DN on the Avaya 3100 Mobile Communicator Gateway, as
shown in the following example.
Avaya 3100 Mobile Communicator Gateway and Avaya Communication Server 2100 Solution Integration Guide
August
Avaya 3100 Mobile Communicator Gateway installation and commissioning
2010
19
Advertisement
Table of Contents
