ETI PI-2500 Instruction Manual page 38

Electrical Test Instruments PI-2500 and PI5000
Section IV - Operating Instructions
==============================================================================
contactor(s) should energize, and green lamp should light.
13. Connect breaker under test to appropriate output tap, using stabs or ca-
bles and series bar as required.
14. Make sure that breaker is CLOSED.
15. Follow Step-by-Step procedures below, as required, for testing.
16. When tests are completed, press INTERLOCK switch to turn Main Power
OFF.
17. Press Control Power Off switch to turn Control Power OFF.
18. Turn off supply power, if possible, and disconnect input power cables.
19. Remove ground cables from Main Control Unit to earth ground.
==============================================================================
Copyright(C) 1994-2008 Electrical Test Instruments, LLC.
Page IV-4
All Rights Reserved