Carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be
kept in good condition. Replace any unreadable or damaged labels.
#00831.0000
#03408.0004
#03409.0004
Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit
requirements.
WARNING - The brewer must be disconnected from the power source until specified.
– Improper electrical installation will damage electronic components. Damage caused by incor-
CAUTION
rect electrical connections is not covered by warranty.
1.
An electrician must provide electrical service with L14-30R receptacle.
2.
If plumbing is to be hooked up later be sure the brewer is disconnected from the power source. If
plumbing has been hooked up, the brewer is ready for Initial Set-Up.
L2 RED
WHITE
NEUTRAL
L1 BLACK
GREEN
120/208 and 120/240 volt ac models
USER NOTICES
#00658.0000
#00824.0002
ELECTRICAL REQUIREMENTS
L2 RED
L2
WHITE
N
NEUTRAL
L1 BLACK
L1
GREEN
G
Note: This electrical service consists of 3 cur-
rent carrying conductors (Neutral, L1 and L2)
and a separate conductor for earth ground.
Page 4
As directed in the International Plumbing Code of the
International Code Council and the Food Code
Manual of the Food and Drug Administration (FDA),
this equipment must be installed with adequate
backflow prevention to comply with federal, state
and local codes. For models installed outside the
U.S.A., you must comply with the applicable Plumb-
ing /Sanitation Code for your area.
#00656.0001
#37881.0000
#38125.0000
48497.2 111017