Bunn Infusion Series Installation & Operating Manual page 15

SET TEMP: 200°
(-) DONE
READY DEGREE 5°
(-) DONE
ENABLE ADS?
NO DONE YES
PROGRAMMING (cont.)
Adjusts brew tank temperature.
RANGE: (185 to 205° F) or (85 to 96° C)
(+)
This function sets the minimum temperature allowable to start a
brew cycle. Range: (2°F to 20°F) or (-16°C to -6°C) below the set
(+)
temperature. The water must be at the "READY" temperature or
higher for the display to indicate "READY TO BREW".
This function allows the operator to choose whether or not to display
an advertising message. An ad can be saved to the brewer by writ-
ing the ad using the programming commands. This message will
be displayed when the brewer is idle.
Procedure to Enable/Disable Ads:
1. The "YES" or "NO" will be flashing to indicate the current selection.
2. Press and release the "NO" switch to disable this function, or:
Press and release the "YES" switch to enable this function.
3. When finished, press and release "DONE" to save the new set-
ting and advance to the next function screen.
4. If "NO" was selected, the display should now read "ENTER SER-
VICE #?". To exit programming and return to the MAIN SCREEN,
press and release the "ENABLE BREW ON/OFF" switch.
5. If "YES" was selected, the display should now read "NEW AD?".
This screen allows you to write a new ad.
6. The display should now read "2 LINES 16 CHARS AVAILABLE",
and then "SCROL THRU ALPHA, NEXT -> NEXT LETTER", and
then "WRITE TOP LINE?". The ad can be up to 32 characters
long, 16 per line. The ad will be written in two steps, first the top
line, then the bottom line.
7. To write the top line of a new ad, press and release "YES". To
skip the top line and only write a bottom line, press and release
"NO" and proceed to step 11. To exit programming and return
to the MAIN SCREEN, press and release the "ENABLE BREW
ON/OFF" switch.
8. The display will now read "A" with a flashing cursor below it. Press
and hold the "SCROLL" switch to scroll through the alphabet
and available characters. When the desired character is shown
on the display, press and release "NEXT" to move to the next
character in the top line.
Page 15
48497.2 111017