Specifications; Standard Accessories; Battery Removal/Installation - Hitachi WR18DSHL Handling Instructions Manual

English
2. Do not pierce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or subject the
battery to severe physical shock.
3. Do not use an apparently damaged or deformed battery.
4. Do not use the battery in reverse polarity.
5. Do not connect directly to an electrical outlets or car
cigarette lighter sockets.
6. Do not use the battery for a purpose other than those
specifi ed.
7. If the battery charging fails to complete even when a
specifi ed recharging time has elapsed, immediately stop
further recharging.
8. Do not put or subject the battery to high temperatures or
high pressure such as into a microwave oven, dryer, or
high pressure container.
9. Keep away from fi re immediately when leakage or foul
odor are detected.
10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove it
from the equipment or battery charger, and stop use.

SPECIFICATIONS

POWER TOOL
Model
Voltage
No-load speed
Ordinary bolt
Capacity
High tension bolt
Tightening torque (Maximum)
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains the
accessories listed in the table below.
1 Charger .............................................. 1
2 Battery ................................................ 2
WR18DSHL
(2LSRK)
3 Plastic case ......................................... 1
4 Battery cover ....................................... 1
WR18DSHL Without charger, battery, plastic case and
(NN) battery cover.
Standard accessories are subject to change without notice.
6
CAUTION
1. If liquid leaking from the battery gets into your eyes, do not
2. If liquid leaks onto your skin or clothes, wash well with
3. If you fi nd rust, foul odor, overheating, discolor,
WARNING
If an electrically conductive foreign object enters the terminals
of the lithium ion battery, a short-circuit may occur resulting
in the risk of fi re. Please observe the following matters when
storing the battery.
○ Do not place electrically conductive cuttings, nails,
○ Either install the battery in the power tool or store
OPTIONAL ACCESSORIES (sold separately)
UC18YRSL
1. Battery (BSL1830)
14.4 V – 18 V
0.6 kg
Optional accessories are subject to change without notice.
APPLICATIONS
Tightening and loosening of all types of bolts and nuts, used
for securing structural items.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
CAUTION
2. Battery installation
rub your eyes and wash them well with fresh clean water
such as tap water and contact a doctor immediately.
If left untreated, the liquid may cause eye-problems.
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
deformation, and/or other irregularities when using the
battery for the fi rst time, do not use and return it to your
supplier or vendor.
steel wire, copper wire or other wire in the storage
case.
by securely pressing into the battery cover until the
ventilation holes are concealed to prevent short-
circuits (See Fig. 1).
WR18DSHL
18 V
1500 /min
M12 – M22
M12 – M16
480 N . m
BSL1830: Li-ion 18 V (3.0 Ah 10 cells)
3.4 kg
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 2).
Never short-circuit the battery.
Insert the battery while observing its polarities (see
Fig. 2).