Nav TV PCM3-997-Media Manual

Adds iPod, AUX, USB-media and Bluetooth to 2009 and Up Porsche 997 vehicles equipped with PCM3 radios
Included in NTV-KIT283 only
SIR-PCM3 Module
Sirius Tuner (SCC1)
NTV-INT021
SIR-PCM3 Power Harness
MOST Fiber
NTV-ASY003
Radio Removal and Installation
On either side of the center console there will be a
1.
carpeted panel. Unscrew the panel (T27 Torx ) and
set aside Remove two T20 screws on each side of
the vinyl (leather) panels that were exposed by
removing the carpeted panel. After the screws have
been removed, take the plastic/vinyl cover and pull
toward rear of vehicle and remove. (Repeat steps for
both passenger and drivers side panels).
There will be (4) Allen screws (2 on each side of the
2.
radio) on the side of the radio. Turn 1/4 turn counter-
clockwise to release the radio.
Pull the radio straight toward the back of the vehicle
3.
and proceed with the installation.
Remove the fiber optic connector from the factory
4.
harness by gently prying up on the locking tab with a
pick tool. With the fiber unplugged from the factory
harness. Plug in the supplied T-harness to the
factory harness. Plug in the Interface module into the
8-Pin connector on the T-harness. Secure the
Interface module in the dash.
P a g e
1 |
PCM3-997-Media
NTV-ASY144
NTV-ASY007
NTV-KIT114/283
Kit Contents
Center Console Dock
NTV-MIS003
PCM3 T-Harness
Dock USB Cable
NTV-HAR102
NTV-CAB018
PCM3-997-Media
3950 NW 120th Ave, Coral Springs, FL 33065
Tel. 561-955-9770 Fax. 561-955-9760
www.nav-tv.com info@nav-tv.com
PCM3 Media Module
NTV-ASY171
Dock Harness
NTV-ASY134
Radio Dash Images
5-19-2014
Rev 2 TY, BM
NTV-DOC180
USB Cable
NTV-CAB009
Ipod Cable
NTV-CAB017