Fiber Module Leds - Honeywell TC-RPFM01 Implemenation Manual

Green/Off
Red/Off

Fiber Module LEDs

The following table summarizes the meaning of typical LED indications on the Fiber
Module. The top LED shows the status of the Channel 1 connection and the bottom one
shows the status of the Channel 2 connection.
If LED is . . .
Off
Flashing Green/Off
Green
R210 Experion PKS ControlNet Fiber Optic Implemenation Guide
10/04
Interpreting Component LED Indications
The system is experiencing temporary network
errors. This condition normally corrects itself. If the
condition persists, check your nodes and cable
system. When checking the cable system, make
sure:
•
All BNC connector pins are properly seated.
•
All taps are connected properly.
•
All coax terminators are 75 ohms and installed at
both ends of all coax segments.
•
Coax cable has not been inadvertently grounded.
The system is experiencing a high level of network
errors. Check for broken cable or tap, and missing
segment terminator.
(Note that this is a normal indication for a system
that has no ControlNet nodes installed or enabled,
since it has no network activity. It is also a normal
indication for a Repeater Adapter used in a Hub
serving as a fiber-to-fiber repeater with no coax
cable connected.)
This means . . .
The Fiber Module is not receiving power from the
Repeater Adapter or the Fiber Module is faulted.
No data activity on the associated channel.
Normal channel operation
Honeywell
ControlNet Fiber Media
21