Symbols Used In This Document; Symbols On The Product; Safety Instructions; Work Procedures - Grundfos BACMON Installation And Operating Instructions Manual

1.1.3 Obligations of the user
• Observe the recognised health and safety regulations as well
as the local accident prevention regulations.
• Wear protective equipment in accordance with local health
and safety regulations when working on the product and
handling chemicals.
• Read and understand this document.

1.2 Symbols used in this document

WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious personal injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
The text accompanying the three hazard symbols DANGER,
WARNING and CAUTION is structured in the following way:
SIGNAL WORD
Description of hazard
Consequence of ignoring the warning.
- Action to avoid the hazard.
A blue or grey circle with a white graphical symbol
indicates that an action must be taken.
A red or grey circle with a diagonal bar, possibly with
a black graphical symbol, indicates that an action
must not be taken or must be stopped.
If these instructions are not observed, it may result in
malfunction or damage to the equipment.
Tips and advice that make the work easier.

1.3 Symbols on the product

If you touch this part of the product, it may lead to
electric shock with consequent risk of serious
personal injury or death.

2. Safety instructions

WARNING
Electric shock
Death or serious personal injury
- Keep liquids away from the power supply and
electrical components.
- Before starting work on the product, make sure
that the power supply has been switched off and
that it cannot be accidentally switched on.

2.1 Work procedures

Before starting to work, make sure to observe the following
points:
• The area must be clean and kept free from objects the user
can trip over.
• There must be sufficient light to operate the product safely.
• If information, symbols and warnings are illegible or unclear,
replace them immediately with new ones.

2.2 Personal protective equipment

There are no requirements for personal protective equipment
during normal operation of the product.
If the analysed liquid contains chemicals or if chemicals are used
for cleaning or flushing, wear personal protective equipment
according to the safety data sheet for the chemical.

3. Storing and handling the product

3.1 Transporting the product

If you need to transport the product after it was
commissioned, contact a Grundfos service specialist.
• Wear safety shoes during transport and installation.
• Wear a helmet if lifting the product higher than hip level.
• Drain the product completely.
• Check and observe the centre of gravity before lifting.
• Use appropriate lifting and transporting equipment.
• Make sure that the product is not exposed to any point load
during the transport.
• Avoid strong impacts.
• If using a forklift, make sure the forks are long enough to
support the weight of the product in its entire depth.
• Observe the permissible ambient conditions. See section
12.3 Ambient conditions.

3.2 Storing the product

• Observe the permissible ambient conditions. See section
12.3 Ambient conditions.
• The storage location must be protected from rain, humidity,
condensation, direct sunlight and dust.
• For storage for a long period of time, prepare the product
according to section
10. Taking the product out of operation.
3