Table of Contents
Advertisement
English (GB) Installation and operating instructions
Original installation and operating instructions
These installation and operating instructions describe the
GRUNDFOS BACMON bacteria sensor.
Sections 1-5 give the information necessary to be able to handle
and install the product in a safe way.
Sections 6-13 give important information about the product, as
well as information on operating and maintaining the product,
taking it out of operation and disposing of it.
CONTENTS
1.
1.1
1.2
1.3
2.
2.1
2.2
3.
3.1
3.2
4.
4.1
4.2
5.
6.
6.1
6.2
6.3
6.4
7.
7.1
7.2
7.3
7.4
7.5
7.6
8.
8.1
8.2
9.
9.1
9.2
10.
10.1
10.2
10.3
10.4
11.
11.1
12.
12.1
12.2
12.3
12.4
12.5
12.6
12.7
12.8
12.9
13.
2
Prior to installation, read this document. Installation
and operation must comply with local regulations and
accepted codes of good practice.
1. General information
This document describes the GRUNDFOS BACMON bacteria
sensor, in the following referred to as the product.
The document must be available and accessible at the
installation location at all times.
Page
2
1.1 Target group
2
This document is intended for the operating company and the
3
users. It contains general instructions that must be observed
3
before installation and during operation and daily maintenance of
3
the product. The responsible staff must read these instructions
3
prior to any work on the product.
3
1.1.1 Qualification and training
3
The persons responsible for the tasks described in this document
3
must be appropriately qualified.
3
Operating company
4
The company or person owning the product or renting the product
4
from Grundfos is referred to as "operating company" in this
4
document. The operating company must coordinate the
4
preparation of the installation location. The installation and the
5
commissioning must be done by Grundfos service specialists.
5
Once the product is in operation, the operating company must
5
coordinate the regular maintenance.
5
Users
6
The persons responsible for operation and daily maintenance of
7
the product are referred to as "users" in this document. The users
7
must be trained on their tasks by the Grundfos service specialists
7
during commissioning, or by the operating company in agreement
7
with Grundfos. The users must be familiar with the product's
7
operation and safety.
7
9
Grundfos service specialists
Grundfos service specialists are responsible for installation,
9
9
commissioning, parameterisation and advanced maintenance of
10
Grundfos products and systems. They have special knowledge,
tools and user rights to be able to perform service and repair
10
tasks that must not be performed by users.
10
10
1.1.2 Obligations of the operating company
11
•
Observe the local safety regulations.
11
•
Keep the installation and operating instructions available at
11
the installation location at all times.
11
•
Coordinate the preparation of the installation location
11
observing section
11
- Provide electrical power.
11
- Provide a foundation for mechanical installation observing
13
section
4.1 Installation
13
- Provide a pre-treatment installation, if required. Contact
13
Grundfos for further information.
13
•
Ensure that the users are trained for their tasks by the
13
Grundfos service specialists during commissioning.
13
13
•
Provide the stipulated safety equipment and personal
13
protective equipment.
13
•
Arrange regular maintenance.
13
13
13
13
13
12. Technical
data.
requirements.
- Quick Links:
- Product Overview
Hide quick links:
Advertisement
Table of Contents
