Table of Contents
Advertisement
1. The appliance is not working.
• Is there a power failure?
• Has the main switch been turned on?
• Has the fuse blown?
• Is the thermostat setting correct?
• Was the appliance switched on correctly?
2. Excessive frost forms inside the
appliance.
• Has the defrost water drain been
repositioned correctly?
• Is the door shut properly?
Before contacting After-Sales Service:
1. See if you can solve the problem yourself
with the help of the Trouble-shooting guide.
2. Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
• the nature of the problem,
• the model,
• the Service number (the number after the
word SERVICE on the data plate on the
inside of the appliance),
• your full address,
• your telephone number and area code.
•
Install the appliance away from heat sources.
Installation in a hot environment, direct
exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will
increase power consumption and should
therefore be avoided.
•
If this is not possible, the following minimum
distances must be respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
•
Install the refrigerator in a dry, well-ventilated
place.
•
Clean the interior (see "How to clean and
defrost the freezer").
•
Fit the accessories.
Electrical connection
•
Electrical connections must be made in
accordance with local regulations.
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
INSTALLATION
3. The yellow, red and green leds do not
light up. Perform the checks for problem
1, and then:
• Contact After Sales Service.
Notes:
•
The front edge of the appliance may be
hot. This prevents the formation of
condensation and is not a defect.
•
Gurgling and hissing noises due to
expansion in the refrigerant circuit are
normal.
Note:
The direction of door opening can be
changed. If this operation is performed by
After-sales Service it is not covered by the
warranty.
•
Voltage and power consumption are
indicated on the rating plate inside the
appliance.
Regulations
•
require that the appliance is
earthed.
The manufacturer declines all liability for
injury to persons or animals and for
damage to property resulting from failure
to observe the above procedures and
reminders.
•
If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
•
Do not use extension leads or adaptors.
Disconnecting the appliance
Electrical disconnection must be possible either
by unplugging the appliance or by means of a
double-pole switch located upline from the
socket.
17
Advertisement
Table of Contents
