Troubleshooting Guide; After Sales Service - Whirlpool CVT65 Quick Start Manual

Table of Contents

Advertisement

1. The temperature in the compartment is
not cold enough
Is the food preventing a proper door closing?
x
Is the freezer too close to a heat source?
x
Are the condenser and the plinth clean?
x
Is the layer of frost on the walls too thick?
x
Is the ambient temperature too low (lower
x
o
than +15
C)?
In this case, it may be useful to set the
thermostat control knob towards position 6 to
allow the compressor to work longer and
provide the adequate storage temperature.
If after these checks, the temperature remains
warm, please contact our After Sale Service and
keep the freezer door closed.
2. The compressor works continuously.
Is the thermostat control knob set to position
x
6?
Is the ambient temperature too warm (higher
x
o
than +32
C)?
Did you open the door frequently?
x
Before calling for Service:
1. Check the Trouble-Shooting Guide carefully to
see if you can correct the fault yourself.
2. Re-operate the appliance to check if the fault
has cleared itself.
If both attempts fail, please call for Service.
Describe the fault and give the model N
o
Service N
of your appliance, your address and
o
phone N
.
TROUBLE SHOOTING GUIDE
AFTER-SALES SERVICE
o
and
3. The freezer does not operate.
Is there a power failure?
x
Is the freezer well plugged?
x
Is the fuse blown?
x
Is the supply cord broken?
x
For Great Britain only
Check that the plug fuse is well fitted. A 3 A
fuse must be used.
Check removable plugs for loose connections
and tighten them if necessary. Loose connections
can overheat the plug.
4. The freezer is excessively noisy.
Is the freezer in contact with other furniture or
x
appliances?
Are the parts in the back in contact with each
x
other?
Attention: Under normal conditions, the cooling
system of the freezer may cause some noise.
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Afg 065bGb733

Table of Contents