Installation - Toshiba BMS-IWF0320E Installation Manual

Smart device control interface
1

Installation

REQUIREMENT
Do not install the unit in any of the following places.
• Humid or wet place
• Dusty place
• Place exposed to direct sunlight
• Place where there is a TV set or radio within one meter
• Place exposed to rain (outdoors, under eaves, etc.)
 Smart device control interface Installation and Orientation
Install and orient the interface using the DIN rail to mount the unit or wall mount or surface mount it as shown below.
Use the supplied mounting bracket to wall mount or surface mount the interface.
(1) DIN rail mount
Install the interface on DIN rails mounted on a switchboard or elsewhere.
Front view
Wall mount A
(3) Surface mount
Use screws to secure the supplied rubber legs to the interface before surface mounting it.
Back view
Wall mount B
Supplied rubber leg
mounting screw
(2) Wall mount
Use screws to attach the supplied
DIN rails to a wall and install the
interface on the DIN rail.
Wall mount C
Supplied rubber leg
Installation Manual
Supplied DIN rail
EN
7-