Operation; Refrigerated Display Cases; Display Lock Operation - Delfield F15 Series Specifications, Installation, Operation & Maintenance Manual

The on-site supervisor is responsible for ensuring that
operators are made aware of the inherent dangers of
operating this equipment.
Do not operate any appliance with a damaged cord
or plug. All repairs must be performed by a qualified
service company.
Never stand on the unit! They are not designed to
hold the weight of an adult, and may collapse or tip if
misused in this manner.
Keep power cord AWAY from HEATED surfaces. DO NOT
immerse power cord in water. DO NOT let power cord
hang over edge of table or counter.
n
Do not contact moving parts.
n
The operator of this equipment is solely responsible
for ensuring safe holding temperature levels for all
food items. Failure to do so could result in unsafe food
products for customers.
n
Do not use electrical appliances or accessories other
than those supplied by the manufacturer.
n
All covers and access panels must be in place and
properly secured, before operating this equipment.
n
Damp or wet hands may stick to cold surfaces.
n
Maximum weight for shelves is 75 pounds. Overloading
shelves can damage equipment or cause bodily injury.
Part Number: 9291460 01/20
DANGER
DANGER
DANGER
DANGER
Warning
Warning
Warning
Warning
Warning
Warning
Section 4

Operation

Do not block the supply and return air grills or the air
space around the air grills. Keep plastic wrappings,
paper, labels, etc. from being airborne and lodging in
the grills. Failure to keep the air grills clear will result in
unsatisfactory operation of the system.
Do not throw items into the display case or storage
area. Failure to heed this recommendation could result
in damage to the interior of the cabinet or to the blower
coil.

Refrigerated Display Cases

Delfield display cases are designed to maintain 36°F to 40°F
(2°C to 4°C) operational temperature in both the display
and storage areas (F15 series only) at 55% or lower ambient
relative humidity.
If humidity is above 55%, condensation on the glass will
be present.

Display Lock Operation

At the factory, the keys are taped to the display case.
To lock: Line up key ridge with red dot.
Insert key and rotate one-half turn.
Remove key and push lock bolt in.
To open: Line up ridge with red dot.
Insert key and rotate key one-half turn.
Remove key.
Warning
n
Caution
,


Notice
13