Philips FC6402 Manual page 9

Problem
Dust escapes from the
appliance.
The brush does not turn
anymore.
The water flow from the
water tank is reduced
The output of water is
faster and larger than
normal.
The floor dries with stripes
when I use the water tank.
Possible cause
The filter is dirty.
The brush encounters too
much resistance.
The wetting strip is blocked
by excessive residue.
The microfiber mopping pad
is not placed correctly. It
covers the wetting strip and
blocks the water flow from
the wetting strip.
The water tank is empty or
nearly empty.
You use a microfiber
mopping pad that is not
supplied by Philips.
If the water tank produces an
uncontrolled and too large
amount of water, the cap
of the tank is probably not
closed properly.
The strip is not placed
properly in the bottom of the
water tank.
You added too much liquid
cleaner to the water.
Solution
Clean the filter.
Clean the brush with a pair of scissors or
by hand. If you clean the roller brush by
hand, pull the hairs or threads from the
widest side to the narrowest side of the
roller brush (see user manual).
Remove the wetting strip and clean it.
Make sure that the Velcro strips on the
mopping pad and the Velcro strips on
the water tank are perfectly aligned.
Also make sure the striped side of the
mopping pad is facing outwards, away
from the bottom of the water tank.
Refill the water tank.
Only use an original Philips microfiber
mopping pad. You can buy these
mopping pads in the online Philips shop
at www.shop.philips.com/service or at
your Philips dealer.
Check the cap and make sure it is fully
and properly closed.
Check the strip and make sure that it is
fitted properly n the bottom plate of the
water tank.
Use only a few drops or use a cleaner
that foams less.
English
9