Napoleon GDI-30N Installation And Operation Instructions Manual
Natural and propane vented gas fireplaces
Hide thumbs
Also See for GDI-30N:
- Installation and operating instructions manual (60 pages) ,
- Installation and operation instructions manual (16 pages) ,
- Installation and operating instructions manual (26 pages)
Related Manuals for Napoleon GDI-30N
Summary of Contents for Napoleon GDI-30N
- Page 1 W415-0384 / E / 12.13.07 W415-0384 / E / 01.04.08 $10.00 W415-0384 / E / 01.04.08...
-
Page 2: Table Of Contents
TABLE of CONTENTS Pg 2-4 INTRODUCTION Pg 8-9 OPERATION / MAINTENANCE Warranty Operating Instructions General Instructions Maintenance General Information BLOWER REPLACEMENT Care of Glass & Plated Parts ADJUSTMENTS INSTALLATION Pilot Burner Adjustment Insert Vent Connection Venturi Adjustments Chimney Connection 11-12 REPLACEMENTS Gas Pipe Installation Wall Switch / Thermostat Ordering Replacement Parts... - Page 3 After the fi rst year, NAPOLEON will not be responsible for installation, labour or any other costs or expenses related to the reinstallation of a warranted part, and such expenses are not covered by this warranty.
-
Page 4: General Instructions
The glass is 3/16" ceramic glass available from your Napoleon of that system at test pressures in excess of 1/2 psig (3.5 kPa). The / Wolf Steel Ltd. -
Page 5: Installation
3" diameter liner for exhaust. The minimum and maximum vent lengths are 10 and 35 feet respectively. Recom- mended Napoleon kits come in 3 lengths: 1-2" & 1-3" DOUBLE PLY ALUMINUM LINER-INLET AND EXHAUST &... -
Page 6: Gas Pipe Installation
with caulking (not supplied). Fasten to the chimney with screws and GRATE INSTALLATION plugs (not supplied). 3. INSIDE: Remove the securing screw from the front of the vent mounting plate. Pull the vent mounting plate only, back into the track, to the front stop. -
Page 7: Finishing
fi rebox side and pulled forward to the grate. PHAZER logs and glowing embers exclusive to Napoleon Fire- The top of the log should rest in the pocket on the back log. places, provide a unique and realistic glowing effect that is different in every installation. -
Page 8: Door Operation
DOOR OPERATION MANTLE CLEARANCE The upper louvres must be removed to allow the door to be opened This can vary according to the mantle depth. Use the graph to help or closed. Release the top and bottom door latches, located at the evaluate the clearance needed. -
Page 9: Maintenance
If ignition takes longer, consult vapours and liquids. The fl ow of combustion and ventilation air your Napoleon dealer/distributor. must not be obstructed. 7. Check that the door gasketing is not broken or missing. Replace 1. -
Page 10: Blower Replacement
BLOWER REPLACEMENT INSTALLATION 1. Turn off the electrical power and the gas supply FIGURE 11 to the fi replace insert. 2. Open the glass door and remove the logs and fi bre bricks, if installed. FIGURE 8 FIGURE 9 BLOWER ACCESS COVER THERMODISC / BRACKET ASSEMBLY 5. -
Page 11: Replacements
Contact your dealer for questions concerning prices and availability WARNING of replacement parts. Normally all parts can be ordered through your Napoleon dealer or distributor. Failure to position the parts in accoardance with these diagrams or When ordering replacement parts always give the following infor-... - Page 12 W415-0384 / E / 01.04.08...
-
Page 13: Trouble Shooting Guide
TROUBLE SHOOTING GUIDE EFORE ATTEMPTING TO TROUBLESHOOT PURGE YOUR UNIT AND INITIALLY LIGHT THE PILOT AND THE MAIN BURNER WITH THE GLASS DOOR OPEN SYMPTOM PROBLEM TEST SOLUTION Pilot will not light. No spark at pilot burner - check if pilot can be lit by a match - check that the wire is connected to the push button ignitor. - Page 14 SYMPTOM PROBLEM TEST SOLUTION Exhaust fumes smelled in - ensure air shutter opening is free of lint or other obstructions. Air shutter has become blocked room, headaches. Flame is impinging on the logs or - check that the logs are correctly positioned. combustion chamber.
- Page 15 W415-0384 / E / 01.04.08...
- Page 16 NOTES W415-0384 / E / 01.04.08...