Napoleon GDIZC - N Instructions Manual
  1. Manuals
  2. Brands
  3. Napoleon Manuals
  4. Indoor Fireplace
  5. GDIZC - N
  6. Instructions manual
Napoleon GDIZC - N Instructions Manual

Napoleon GDIZC - N Instructions Manual

Gas-fired direct vent insert
Hide thumbs Also See for GDIZC - N:
Table of Contents

Advertisement

Quick Links

INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.33, ANSI Z21.88 FOR VENTED GAS FIREPLACE HEATERS
INSTALLATION AND OPERATION INSTRUCTIONS FOR:
WARNING: If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
Installation and service must be performed by a qualified installer, service
R-2000
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031
GAS-FIRED DIRECT VENT INSERT
VENTED GAS FIREPLACE HEATER
NATURAL GAS MODELS
PROPANE GAS MODELS
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI / CSA METHODS
FOR YOUR SAFETY
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
agency or the gas supplier.
www.napoleonfireplaces.com • ask@napoleon.on.ca
GDIZC - N
GDIZC - P
• Immediately call your gas supplier
from a neighbour's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
1
W415-0223 / D / 01.12.04

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GDIZC - N and is the answer not in the manual?

Questions and answers

Related Manuals for Napoleon GDIZC - N

Summary of Contents for Napoleon GDIZC - N

  • Page 1 Installation and service must be performed by a qualified installer, service agency or the gas supplier. R-2000 Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031 www.napoleonfireplaces.com • ask@napoleon.on.ca W415-0223 / D / 01.12.04...

  • Page 2: Table Of Contents

    TABLE of CONTENTS Pg 2-4 INTRODUCTION Pg 9 OPERATION / MAINTENANCE Warranty Operating Instructions General Instructions Maintenance General Information REPLACEMENT BLOWER Care of Glass & Plated Parts ADJUSTMENTS INSTALLATION Pilot Burner Adjustment Insert Vent Connection Vent Restrictions Chimney Connection Venturi Adjustments Wall Switch / Thermostat 12-13 REPLACEMENTS Gas Pipe Installation...
  • Page 3 After the first year, NAPOLEON will not be responsible for installation, labour or any other costs or expenses related to the reinstallation of a warranted part, and such expenses are not covered by this warranty.

  • Page 4: General Instructions

    GENERAL INFORMATION GENERAL INSTRUCTIONS THIS GAS FIREPLACE INSERT SHOULD BE INSTALLED FOR YOUR SATISFACTION, THIS FIREPLACE INSERT AND SERVICED BY A QUALIFIED INSTALLER to con- HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION form with local codes. Installation practices vary from re- AND QUALITY! gion to region and it is important to know the specifics that Minimum inlet gas supply pressure is 4.5 inches water...

  • Page 5: Installation

    INSTALLATION Clean out ashes from the inside of the wood-burning fire- Provide adequate ventilation air. place. Make sure that the chimney and wood-burning fire- Provide adequate accessibility clearance for place are in a clean and sound condition and constructed servicing and operating the fireplace insert. of non-combustible materials.

  • Page 6: Insert Vent Connection

    The minimum and maximum vent lengths FIGURE 4 are 10 and 35 feet respectively. Recommended Napoleon kits come in 3 lengths: While the liners must be continuous from the fireplace to the terminal, to achieve the needed length, they may be coupled, using an aluminium coupler, provided installation is sealed &...

  • Page 7: Wall Switch / Thermostat

    WALL SWITCH / THERMOSTAT GAS INSTALLATION Install suitable supply piping connection to the " flex For ease of accessibility, an optional remote wall switch connector supplied (as per local gas codes). or millivolt thermostat may be installed in a convenient location.

  • Page 8: Log Placement

    Take the time to carefully position the glowing embers for a maximum glowing effect. Use only certified PHAZER logs available from your Napoleon / Wolf Steel Ltd. dealer. 1. Place the rear log (#1) onto the two log supports and against the air intake pipe.

  • Page 9: Operation / Maintenance

    5-10 second total light-up period is satisfactory. If ignition 1. In order to properly clean the burner and pilot assembly, takes longer, consult your Napoleon dealer/distributor. remove the logs exposing both assemblies. 7. Check that the door gasketing is not broken or missing.
  • Page 10 OPTIONAL BLOWER INSTALLATION THERMODISC B R A C K E T BLOWER ASSEMBLY WIRES FIGURE 21 FIGURE 24 4. Disconnect the two blower wires. Remove the blower bracket secured with one wing nut and lock washer. 1. Turn off the electrical power and the gas supply to the For thermodisc replacement: Remove the "Z"...

  • Page 11: Adjustments

    ADJUSTMENTS PILOT BURNER ADJUSTMENT VENTURI ADJUSTMENT Remove the pilot screw cap. Adjust the pilot screw to pro- This unit is approved for use with a 2" liner for air intake vide properly sized flame. Turn in a clockwise direction to and a 3"...

  • Page 12: Replacements

    Contact your dealer for questions concerning prices and When ordering replacement parts always give the follow- availability of replacement parts. Normally all parts can be ing information: ordered through your Napoleon dealer or distributor. 1. M & S ODEL ERIAL UMBER OF FIREPLACE 2.
  • Page 13 W415-0223 / D / 01.12.04 WARNING: This is a fast acting thermocouple. It is an integral safety component. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

  • Page 14: Trouble Shooting Guide

    TROUBLE SHOOTING GUIDE EFORE ATTEMPTING TO TROUBLESHOOT PURGE YOUR UNIT AND INITIALLY LIGHT THE PILOT AND THE MAIN BURNER WITH THE GLASS DOOR REMOVED SYMPTOM PROBLEM TEST SOLUTION Pilot will not light. No spark at pilot burner - check if pilot can be lit by a match - check that the wire is connected to the push button ignitor.
  • Page 15 SYMPTOM PROBLEM TEST SOLUTION REFER TO "MAIN BURNER GOES OUT; PILOT STAYS ON" Main burner goes out; pilot goes out. Vent re-circulating - check joint seals and installation. Thermocouple shorting or - loosen and tighten thermocouple faulty. - clean thermocouple and valve connection. - replace thermocouple.
  • Page 16 Wolf Steel Fireplace Service History This fireplace must be serviced annually depending on usage. Service Technician Date Dealer Name Service Performed Special Concerns Name...

This manual is also suitable for:

Gdizc - p

Table of Contents