Stihl MS 661 Manual page 83

1
: Take out the screw (1), push the
tank housing (2) down a little and
hold it there.
1
: Unscrew the AV element (1) from
the tank housing and disconnect
the retainer.
– Inspect the plug, spring and
retainer, replace if necessary.
Installing
– Preassemble the plug, spring
and retainer.
1
– Push the tank housing down a
little and hold it there.
82
: Fit AV element (1) with retainer
on tank housing stub (arrow) and
screw it home as far as stop.
2
2
: Lift the tank housing (1) until
holes in bearing plug (2) line up.
: Insert and tighten down the
screw (3) firmly.
1
1
: Insert and tighten down the
screws (1) on the underside of
the machine.
2
3
1
: Lift the handlebar (1) sideways
and position it in the
guide (arrow) so that the peg (2)
engages the seat in the
crankcase.
3
1
4
On versions with handle heating,
check that wires are properly
positioned.
: Position cover (1) with bosses in
holes in handlebar (2), making
sure the tab (3) engages the
groove (arrow).
: Insert and tighten down the
screws (4) firmly.
MS 661, MS 661 C-M
1
2
4