Segment - Stihl MS 661 Manual

Installing new rewind spring
1
– Lubricate the replacement spring
with frame with a few drops of
STIHL special lubricant before
installing, b 16
: Position the replacement spring
with frame in the fan housing and
push it into its seat (arrow) – the
anchor loop must be above the
lug (1).
– Remove the frame – keep it if
necessary.
The rewind spring must be properly
seated – if necessary, push it fully
into its seat and onto the lug.
Installing unwound rewind spring
If the rewind spring has popped out,
refit it in the fan housing as follows:
MS 661, MS 661 C-M
: Fit the anchor loop in its
seat (arrow) in the frame.
: Fit the rewind spring (1)
counterclockwise in the frame,
holding the windings steady in
the process.
The procedure is otherwise the
same as that for installing a new
rewind spring.
– Reassemble all other parts in the
reverse sequence.
9.8

Segment

– Remove the rewind starter,
b 9.2
3 1
: Lift the segment (1) at the recess
(arrow) and tab (2) until the
pegs (3) are clear of the holes.
– Inspect the segment, replace if
necessary
Installing
1
: Engage the segment (1) in the
slots (arrows) in the fan housing
first and then swing it into
position.
1
: Press the pegs (1) of
segment (2) into the holes as far
as stop, making sure the tab (3)
engages over the rib and the
tabs (arrows) locate in their
2
seats.
– Reassemble all other parts in the
3
reverse sequence.
1
2 3
1
79